Do not subject your Monitor to
impact of any kind. Be particularly
careful not to damage the screen
Unplug the Monitor from the wall
outlet before cleaning. Do not use
liquid cleaners or spray-type
cleaners. Use a damp cloth for
11-1. Do not place this Monitor on an
unstable, uneven or an inclined
location. The Monitor may
overturn, causing serious injury
(to a person), and serious damage
to the appliance.
11-2. Be careful when placing the
Monitor on a cart to move it.
Quick stops, excessive force, and
uneven surfaces may cause the
Monitor and cart to overturn.
· Do not use the Monitor near
water, for example, near a
bathtub, washbowl, kitchen sink,
or laundry tub, in a wet basement,
or near a swimming pool, etc.
· Never expose the Monitor to rain
If the Monitor system has been
exposed to rain or water, unplug
the Monitor from the wall outlet
and refer servicing to qualified
Choose a place where light (artificial
or sunlight) does not shine directly
on the screen.
Avoid dusty places since the
buildup of dust inside the Monitor's
· The Monitor has slots, or
openings in the cabinet for
ventilation purposes to ensure the
reliable operation of the Monitor,
and to protect it from overheating.
These openings must not be
blocked or covered.
with cloth or other material.
· Never block the bottom
ventilation slots of the Monitor by
placing it on a bed, sofa, rug, etc.
· Never place the Monitor near or
over a radiator or heat register.
in enclosure such as a bookcase,
unless proper ventilation is
PROTECTION AND LOCATION OF YOUR PROJECTION MONITOR RECEIVER
If an outside antenna is connected through other
equipment, be sure the antenna system is grounded so
as to provide protection against voltage surges and built-
up static charges. In the U. S. A., section 810 of the
National Electrical Code, ANSI/NFPA 70, provides
information on proper grounding of the mast and
supporting structure, grounding of the lead-in wire to
an antenna-discharge unit, size of grounding
conductors, location of antenna-discharge unit,
connection to grounding electrode, and requirements
for the grounding electrode.
EXAMPLE OF ANTENNA GROUNDING IN
NATIONAL ELECTRICAL CODE INSTRUCTIONS
LEAD IN WIRE
(NEC SECTION 810-20)
(NEC SECTION 810-21)
POWER SERVICE GROUNDING
(NEC ART 250, PART H)