PDP-S59
2
12
3
4
12
3
4
C
D
F
A
B
E
1. REASSEMBLY AND DISASSEMBLY PRECAUTIONS
1.1 GRILLE ASSY
The Grill Assy is secured to the baffle plate with two-sided tape and
bosses. When removing the Grill Assy, if is necessary to wear cot-
ton gloves.
Disassembly
1. Insert the tip of your gloved finger into the gap between the
Grill Assy in front and the corner of the baffle plate so that the
Grill Assy is slightly lifted.
2. Insert the gloved finger to the extent of the second joint into the
gap between the cabinet and the Grill Assy.
3. Alternately and gradually lift the left and right sides of the Grill
Assy by about 5 cm, sliding gloved fingers along the cabinet. When
lifting the Grill Assy, be sure to lift the left and right sides alternate-
ly, but not both sides simultaneously.
Note: Be careful not to bend the Grill Assy too far. Otherwise, it
may be damaged.
O : Good example X : Bad example
Reasassembly
When reassembling the Grill Assy
Remove the old two-sided tape attached to the rear panel of the
Grill Assy and adhere new two-sided tape. Press the bosses into the
baffle plate and press the entire grill into position.
1.2 WOOFER (Disassembly)
The woofer is secured to the baffle plate with four screws from the
outside. To remove the woofer, first remove the baffle plate. (Re-
move the baffle plate first, because the cables from the Network
Assy are short.)
Reasassembly
When reassembling the woofer, place it so that its connector plate
is facing downward.
1.3 TWEETER (Disassembly)
The tweeter is secured to the baffle plate with three screws from
the outside. To remove the tweeter, first remove the baffle plate.
(Remove the baffle plate first, because the cables from the Net-
work Assy are short.)
Reasassembly
When reassembling the tweeter, place it so that its connector and
screw -hole positions aliga with those on the baffle plate.
Network Assy (Caution)
· When removing the Network Assy, pull it out a little at a time
from alternate sides, because it is seated tightly.
Baffle Assy (Caution)
· When reassembling the cabinet and the baffle plate, secure the
screws in the order shown in the figure below:
Grille ASSY
Baffle
Grille ASSY
Baffle
Network ASSY
1
2
1
Input terminal
Baffle
5
4
3
2
1
